Fire-protected charging compartment for lithium-ion batteries WFP-X 6 Li-Ion Charge

• Ready-to-connect, fire-protected charging compartments from DENIOS offer a safe and efficient way to reliably charge a variety of batteries
• Acceleration of the approval process thanks to tested and certified fire protection for 90 or 120 minutes (REI90 / REI120) from the inside and outside
• Can be installed directly on the outer wall of buildings or in a vehicle hall
• Customised design of loading areas with shelves and/or mounting rails for any type of charger
• Costly new power lines can be avoided: intelligent charging management controls the chargers in such a way that the charging power required at any one time is optimised and reduced
• Visualization of CO2, fuel and cost savings
• Optional technical ventilation or air conditioning prevents heat build-up during charging of the lithium batteries.
• Fully integrated extinguishing technology
• Can be combined with DENIOS connect
• Targeted roof drainage
• Further optional extras available, such as green roofs

Structural analysis

The structural calculations for the technical room system are based on Eurocode 3 (EN 1993). The loads on the structure are measured according to Eurocode 1 (EN 1991-1-3) for a characteristic wind load qk,w = 0.585 kN/m² and a ground snow load sk = 2.5 kN/m². The structure is also designed for earthquake zone 3 according to EN 4149, EN 1998-1:2004. With additional equipment up to wind load zone 4 with terrain category I (qk,w = 1.064 kN/m²) or up to ground snow load sk = 5.86 kN/m².

Roof drainage

Roof drainage channels rain water to the frame running around the edge and drains it away on the short sides either to the left or the right.